GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual page 145

Display
Message
PRES3 ER Temperature compensated pressure sensor 3
(supply) reading is outside of range.
PRES4 ER Temperature compensated pressure sensor 4
(pilot) reading is outside of range.
PRES5 ER Temperature compensated pressure sensor 5
reading is outside the range
WATCHDOG_- Watchdog event from which the positioner
TIMEOUT recovered automatically.
NVM ERR-W Writer to FRAM fails or data repairing in FRAM
fails
IRQ FAULT Valid hidden record (in RAM) existing upon reset
that indicates that an illegal interrupt occurred
TMOUT_- If a round of flash test is not completed in 2 hrs. Warning
FLASH_TEST
MCU ERR 1 Micro-Controller Self Check failed
SW ERR Software self check error
UI_OFF Display is turned off because it is not responsive
at low (main board) temperature, -10 deg.C.
IPC_LOST Electronics failure.
SETPOINT_- Timeout of GOOD setpoint delivery from FF.
TIMEOUT
FSTATE_REQ Failed State requested by FF.
NEWDIAG- New baseline signature successfully saved
SIGN_BASE- (should be cleared by host on read).
LINE
NEWDIAG- New user signature successfully saved (should
SIGN_USER be cleared by host on read).
IPC_DISCON- Electronics failure.
NECT
POS_CUT- Indicator of position cut-off high (at open stop).
OFF_HI
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.
Table 30 Error Messages (Continued)
Description Category Cause
Warning Electronic hard-
ware
Failsafe Electronic hard-
ware
Warning Electronic hard-
ware
Warning Electronic hard-
ware
Logonly Electronic hard-
ware
Logonly Electronic hard-
ware
Electronic hard-
ware
Failsafe Electronic hard-
ware
Warning CPU/firmware
Lgonly Ambient tempera-
ture.
Failsafe Electronic hard-
ware
Warning Electronic hard-
ware
Failsafe Electronic hard-
ware
Lgonly N/A
Lgonly N/A
Lgonly Electronic hard-
ware
Lgonly N/A
Masoneilan SVI FF Instruction Manual
Byte_
Bit
4_7
5_0
5_1
5_2
5_3
5_4
5_5
5_6
5_7
7_4
7_6
7_7
8_0
8_1
8_2
8_3
8_4
| 145
=