GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual page 175

Parameter (in bold)
Sub-parameter (Index)
DEADBAND (3)
TIME (4)
ALERT (5)
HISTORIC ALERT (6)
ENABLE (7)
FIND_STOPS (67)
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.
Table 31 Transducer Block Parameters (Continued)
Initial
Mode
Range
Value
from 0 to 5
20
1 to 60 60
FALSE FALSE
True - FALSE
False
True - TRUE
False
0 Man
Description
Not writable for Standard Diagnostics version.
The user defined allowable duration in seconds of CUR-
RENT below ALERT_POINT before alert is set to True.
Not writable for Standard Diagnostics version.
True if the CURRENT has reached below ALERT_POINT and
have not come above ALERT_POINT.
Not writable for Standard Diagnostics version.
True if ALERT is true.
Not changed if ALERT is false.
Not writable for Standard Diagnostics version.
True - Enables the ALERT to be reported according to the
configuration.
False - Disables ALERT reporting.
Not writable for Standard Diagnostics version.
Should be used by method or DTM only.
Find Stops - Writing to the FIND_STOPS parameter triggers
execution of the following commands in the valve:
1, Find stops Start - starts an automatic full find stops
process.
2, Find stops Cancel - cancels a find stops process (full
or partial).
3, Find stops Set Closed - moves the valve to full
closed position.
4, Find stops Set Open - moves the valve to full open
position.
5, Find stops Accept - accepts the valve position as
one of the stops - not finalized until commit.
6, Find stops Commit - saves the stop positions
changed and recalculates scaling factors.
11, Find stops Running (un-selectable) - read only.
0, Find stops Not running (un-selectable - read only.
Note, that FIND_STOPS can be started only when the TB is
in MAN mode. The expectation is that the method or the
DTM will not allow you to change the mode before the
operation is completed.
Masoneilan SVI FF Instruction Manual
| 175
=