GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual page 152

Parameter (in bold)
Sub-parameter (Index)
VALUE (5)
TRANSDUCER_
DIRECTORY (9)
NUMBER_OF_XDS (1)
POSITIONER_INDEX (2)
PRESSURES_INDEX (3)
TEMPERATURE_INDEX
(4)
POSITION_
TRANSDUCER_TYPE
(10)
XD_ERROR_POS (11)
FINAL_VALUE (12)
STATUS (1)
VALUE (2)
FINAL_VALUE_RANGE
(13)
EU_100 (1)
EU_0 (2)
152 |
BHGE
Table 31 Transducer Block Parameters (Continued)
Initial
Mode
Range
Value
0 0
3 3
10 10
48 48
59 59
106 106
0 0
Man
100 100
0 0
Description
The value of the associated parameter at the time the
alert was detected, except that for multi-bit alarms, the
value is 0 (zero).
Number of transducers in the device.
Index of the positioner transducer.
Index of the supply pressure transducer.
Index of temperature transducer.
Indicates that it is the advanced positioner valve.
The following errors can be reported in the XD_ERROR
parameter:
0 No Error.
16 Unspecified error (to be mapped to Other in Block
Error.
17 General error.
18 Calibration error.
19 Configuration error.
20 Electronics Failure.
21 Mechanical Failure.
22 I/O Failure.
23 Data Integrity Error.
24 Software Error.
25 Algorithm Error.
The requested valve position and setpoint status written
by an Analog Output block. The output is used as the set-
point when controlled in Man mode.
The status written by the Analog Output FB.
The requested valve position, written by the AO FB.
The range of the FINAL_VALUE (setpoint) and the
FINAL_VALUE_RANGE (actual position).
This parameter is not changeable.
Max Position value at 100%. Fixed to 100.
Min Position value at 100%. Fixed to 0.
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.