Appendix F. Transducer Block Parameters - GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual

Appendix F. Transducer Block Parameters

Table 31 lists the Transducer block parameters.
CAUTION
NOTE
Parameter (in bold)
Sub-parameter (Index)
BLOCK_INFO (0)
Block Tag (1)
DD_MEMBER (2)
DD ITEM (3)
DD REVIS (4)
Profile (5)
Profile Revision (6)
Execution Time (7)
EXECUTION_PERIOD (8)
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.
Once finished with any DD-based configuration you must return to
Normal mode, Use the APP_MODE command to do this from the DD. See
"Changing Out of LO Mode" on page 251.
In the Transducer block each alert has an Active and Historical bit.
Active bit presents the current state of the condition. Historical bit
indicates whether the condition occurred in the past. Both are
user clearable.
Table 31 Transducer Block Parameters
Initial
Mode
Range
Value
0
20018
0x0001
8060
01
0
0
Description
Block tag is detected by the application is use.
DD member ID defined by DD tokenizer, when the DD is
created (constant).
DD member ID defined by DD tokenizer, when the DD is
created (constant).
DD revision.
Hard-coded to Custom Transducer block (constant).
0 indicates that this block does not need to be scheduled
(constant).
0 indicates that this block does not need to be scheduled.
Masoneilan SVI FF Instruction Manual
| 149
=