EMC Connectrix EC-1200 Planning Manual page 29

3 DS-xxM
4 DS-xxM
2 ED-140M
1 ED-1032
Figure 1-10
Stabilizer/Outrigger
Brackets
1 ED-140M
EC-1200 Cabinet Configuration Examples 21 – 24
Connectrix stabilizer/outrigger brackets (P/N 100-605-014) mount to
the bottom front and rear of the EC-1200 cabinet to prevent tipping.
When the EC-1200 cabinet is positioned such that it is not
immediately adjacent (within 2 inches) to another equipment cabinet,
the stabilizer/outrigger brackets must be positioned in their
outermost position. (Refer to Figure 1-11.) If the cabinet is positioned
within 2 inches of another equipment cabinet, the outrigger brackets
can be positioned in their innermost position.
Any side of the EC-1200 cabinet that is not within 2 inches of another
equipment cabinet should have that side's outriggers positioned in
the outermost position. These rules apply not only for initial
installation, but also if the EC-1200 switch/director configuration is
altered at a later date.
2 ED-140M
1 ED-140M
EC-1200 Connectrix Cabinet
3 ED-140M
2 ED-140M
1 ED-140M
EC-1200 Overview
1
1-15