Lantronix SGX 5150 Command Reference Manual page 97

dress
show
show history
start ip address <IP ad-
dress>
start ipv6 address <ipv6
address/prefix>
state enable
static leases <number>
write
diagnostics (config-diagnostics) level commands
clrscrn
exit
log
show
show history
write
disconnect (tunnel-disconnect:4) level commands
clrscrn
exit
flush serial disable
flush serial enable
flush stop character dis-
able
flush stop character ena-
ble
modem control disable
modem control enable
no stop character
no timeout
show
show history
stop character <control> Sets the stop character. The character may be input as text, control, decimal, or hex. A
timeout <milliseconds>
write
disconnect (tunnel-disconnect:3) level commands
clrscrn
exit
flush serial disable
flush serial enable
flush stop character dis-
able
SGX™ 5150 IoT Device Gateway Command Reference
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Sets the start IP address of DHCP address pool.
Sets the start IPv6 address of DHCP address pool. IPv6 addresses are written in eight
groups of four hexadecimal digits separated by colons, such as
2001:0db8:85a3:0000:0000:8a2e:0370:7334 Network address ranges are written in CIDR
notation. A network is denoted by the first address in the block (ending in all zeroes), a
slash (/), and a decimal value equal to the size in bits of the prefix
Enables DHCP server.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
Clears the screen.
Returns to the config level.
Enters the next lower level.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
Clears the screen.
Returns to the tunnel level.
Does not flush serial data upon closing a tunneling connection.
Flushes serial data buffer when a tunneling connection is closed.
Forwards the stop character from the Line to the network.
Prevents the stop character from the Line from being forwarded to the network.
Does not watch the modem control pin to disconnect.
Watches the modem control pin and disconnects if it is not asserted.
Removes the stop character.
Disables disconnect after timeout feature for tunneling sessions.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
control character has the form <control>C. A decimal value character has the form \99. A
hex value character has the form 0xFF.
Disconnects when no data has been received on the line (serial port) for the specified
length of time. <milliseconds> = timeout in milliseconds.
Stores the current configuration in permanent memory.
Clears the screen.
Returns to the tunnel level.
Does not flush serial data upon closing a tunneling connection.
Flushes serial data buffer when a tunneling connection is closed.
Forwards the stop character from the Line to the network.
5: Commands and Levels
97