Lantronix SGX 5150 Command Reference Manual page 324

modem (tunnel-modem:1) level commands
clrscrn
connect string <text>
default incoming connec-
tion
default response type
display remote ip disable The incoming RING has nothing following it.
display remote ip enable The incoming RING is followed by the IP address of the caller.
echo commands disable Does not echo modem commands.
echo commands enable
echo pluses disable
echo pluses enable
error unknown com-
mands disable
error unknown com-
mands enable
exit
incoming connection
automatic
incoming connection
disabled
incoming connection
manual
no connect string
reassert
response type numeric
response type text
show
show history
show status
verbose response disa-
ble
verbose response enable Sends Modem Response Codes out on the Serial Line.
write
ntp (config-clock-ntp) level commands
clrscrn
default server
exit
server <text>
show
show history
write
on scheduled reboot (config-action:on scheduled reboot) level commands
clrscrn
default delay
delay <seconds>
SGX™ 5150 IoT Device Gateway Command Reference
Clears the screen.
Sets the CONNECT string used in modem emulation. <string> = connect string.
Default disables incoming network connections.
Default uses text type responses.
Echoes modem commands.
Does not echo the +++ characters when entering modem command mode.
Echoes the +++ characters when entering modem command mode.
Returns OK on unknown AT commands.
Returns an error upon unknown AT commands.
Returns to the tunnel level.
Automatically answer incoming network connections.
Disable incoming network connections.
Wait for an ATA command before answering an incoming network connection.
Removes optional CONNECT string information for modem emulation.
Asserts tunnel modem status with current configured values.
Uses numeric type responses.
Uses text type responses.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays tunnel modem status.
Does not send Modem Response Codes.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the default NTP server address.
Exits to the next higher level.
Sets the NTP server address.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
Clears the screen.
Resets alarm processing delay to its default value.
Sets the delay in processing the alarm. Alarm actions will not be executed if the cause is
corrected within this time.
5: Commands and Levels
324