Lantronix SGX 5150 Command Reference Manual page 241

host 28 (config-host:28) level commands
clrscrn
default protocol
default remote port
exit
host <number>
name <text>
no name
no remote address
no ssh username
protocol ssh
protocol telnet
remote address <text>
remote port <number>
show
show history
ssh username <text>
write
host 29 (config-host:29) level commands
clrscrn
default protocol
default remote port
exit
host <number>
name <text>
no name
no remote address
no ssh username
protocol ssh
protocol telnet
remote address <text>
remote port <number>
show
show history
ssh username <text>
write
host 3 (tunnel-connect-host:4:3) level commands
address <text>
aes decrypt key <hexa-
decimal>
SGX™ 5150 IoT Device Gateway Command Reference
Clears the screen.
Restores the default value of the protocol (Telnet).
Sets the remote port (used to connect to the host) to the default value, which depends on
the selected protocol.
Exits to the configuration level.
Change to config host level
Sets the name of the host. <text> = name of the host.
Clears the name of the host.
Clears the remote address of the host.
Clears the SSH username associated with the host.
Sets the protocol to SSH.
Sets the protocol to Telnet.
Sets the IP address of the remote host to connect to when this host is selected on the login
connect menu. <text> = IP address.
Sets the remote port used to connect to the host. <number> = port to be used.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Sets the username for logging into the host via SSH. <text> = username.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the default value of the protocol (Telnet).
Sets the remote port (used to connect to the host) to the default value, which depends on
the selected protocol.
Exits to the configuration level.
Change to config host level
Sets the name of the host. <text> = name of the host.
Clears the name of the host.
Clears the remote address of the host.
Clears the SSH username associated with the host.
Sets the protocol to SSH.
Sets the protocol to Telnet.
Sets the IP address of the remote host to connect to when this host is selected on the login
connect menu. <text> = IP address.
Sets the remote port used to connect to the host. <number> = port to be used.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Sets the username for logging into the host via SSH. <text> = username.
Stores the current configuration in permanent memory.
Sets the remote host to establish tunneling connections with. <text> = IP address or host
name of the remote host.
Sets the connect tunnel AES decrypt key with up to 16 bytes. Each byte is represented by
two adjacent hex digits. Bytes may run together or be separated by optional punctuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc Note that quotes must enclose the value
if it contains spaces.
5: Commands and Levels
241