Lantronix SGX 5150 Command Reference Manual page 311

terminal <line>
terminal network
threshold <bytes>
tunnel <line>
usb <line>
write
xoff char <control>
xon char <control>
line 1 (config-mach10-line:1) level commands
clrscrn
command delimiter
<text>
content check interval
<hours>
default command delim-
iter
default content check
interval
default local port
default status update
interval
exit
line <number>
local port <number>
no project tag
project tag <text>
show
show history
state disable
state enable
status update interval
<minutes>
write
line 2 (line:2) level commands
auto show statistics
baud rate <bits per sec-
ond>
bluetooth serial <line>
clear line counters
clrscrn
command mode always
SGX™ 5150 IoT Device Gateway Command Reference
Enters the configure-terminal level. <line> = number of the terminal line (serial port) to be
configured.
Enters the configure-terminal level for the network.
Sets the threshold in bytes. After this many bytes are received, they are forwarded without
delay.
Enters the tunnel level. <line> = number of the tunnel line (serial port) to be configured.
Enters the usb level. <line> = number of the line (usb port) to be configured.
Stores the current configuration in permanent memory.
Sets the xoff character for use with software flow control on this line. The character may be
input as text, control, decimal, or hex. A control character has the form <control>C. A dec-
imal value character has the form \99. A hex value character has the form 0xFF.
Sets the xon character for use with software flow control on this line. The character may be
input as text, control, decimal, or hex. A control character has the form <control>C. A dec-
imal value character has the form \99. A hex value character has the form 0xFF.
Clears the screen.
Sets the command delimiter.
Sets the firmware and configuration check interval.
Restores the command delimiter.
Restores the default firmware and configuration check interval.
Clears the local port for Mach10 client.
Restores the default status update interval.
Exits to the config-mach10 level.
Change to line configuration level.
Sets the local port for Mach10 client. When configured, a total of 16 consecutive ports will
be reserved.
Restores the default Project Tag.
Sets the Project Tag.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Disables command processing on line.
Enables command processing on line.
Sets the status update interval.
Stores the current configuration in permanent memory.
Continuously displays line statistics.
Sets the line speed. <bits per second> = the speed. Standard speeds include 1200, 2400,
4800, 9600, 19200, and so on.
Enters the bluetooth serial level. <line> = number of the line (bluetooth serial port) to be
configured.
Sets the serial counters to zero.
Clears the screen.
Sets the current line to always be in command mode.
5: Commands and Levels
311