Lantronix SGX 5150 Command Reference Manual page 351

clrscrn
exit
ip address <IP address> Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
no ip address
no ipv6 address
no mac address
show
show history
static leases <number>
write
static leases 8 (config-dhcpd-static_leases:8) level commands
clrscrn
exit
ip address <IP address> Sets the reserved IP address.
ipv6 address <ipv6 ad-
dress/prefix>
no ip address
no ipv6 address
no mac address
show
show history
static leases <number>
write
static route 1 (config-staticroute:1) level commands
clrscrn
default metric
exit
friendly name <text>
gateway <text>
interface <text>
metric <number>
network <text>
no friendly name
no gateway
no interface
no network
show
show history
state disable
SGX™ 5150 IoT Device Gateway Command Reference
Clears the screen.
Exits to the config-dhcpd level.
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Removes the MAC Address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
Clears the screen.
Exits to the config-dhcpd level.
Sets the reserved IPv6 address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Clears the reserved IP address.
Clears the reserved IPv6 address.
Removes the MAC Address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Change to dhcpd static lease level.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the metric to default value.
Exits to the config-gateway level.
Set the friendly name for static route. <text> = friendly name
Sets the gateway for static route network.
Sets the route interface <text> = interface name
Sets the metric for static route. <number> = metric
Sets the IP address and network mask for static route network.
Remove the friendly name
Clears the gateway for static route network.
Clears the route interface. The WAN interface is used if no interface is specified.
Clears the IP address for static route network.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Disables the static route.
5: Commands and Levels
351