Lantronix SGX 5150 Command Reference Manual page 310

command mode wait
time <milliseconds>
configure current settings Configures line with the current value of settings.
data bits 7
data bits 8
default baud rate
default data bits
default flow control
default parity
default stop bits
default threshold
default xoff char
default xon char
exit
flow control hardware
flow control none
flow control software
gap timer <milliseconds> Sets the gap timer in milliseconds. If some data has been received, it will be forwarded
kill session
line <line>
name <text>
no clear line counters
no command mode
no command mode si-
gnon message
no gap timer
no name
parity even
parity none
parity odd
protocol modbus ascii
protocol modbus rtu
protocol none
protocol tunnel
reassert
show
show command mode
show history
show line
show statistics
state disable
state enable
stop bits 1
stop bits 2
SGX™ 5150 IoT Device Gateway Command Reference
Sets boot-up wait time for command mode serial string. <milliseconds> = wait time.
Uses seven bits for data on the line.
Uses eight bits for data on the line.
Restores the default speed of 9600 bits per second.
Restores the default of eight data bits.
Restores the default of no flow control.
Restores the default of no parity.
Restores the default of one stop bit.
Restores the factory default threshold.
Restores the default xoff character on this line.
Restores the default xon character on this line.
Exits to the enable level
Uses hardware (RTS/CTS) flow control on the line.
Does not provide flow control on the line.
Uses software (xon/xoff characters) flow control on the line.
after this time since the last character.
Kills command mode session on the Line
Enters the line level. <line> = number of the line (serial port) to be configured.
Sets the name for this line.
Restores the serial counters to the aggregate values.
Disables command mode for the current line.
Clears the signon message displayed at boot time and when entering command mode.
Removes the gap timer, so forwarding depends on the line speed.
Removes the name of this line.
Uses a parity bit on the line for even parity.
Does not use a parity bit on the line.
Uses a parity bit on the line for odd parity.
Applies Modbus ASCII protocol on the line.
Applies Modbus RTU protocol on the line.
Uses no protocol on the line.
Applies tunnel protocol on the line.
Asserts line status with current configured values.
Displays the current status.
Shows the command mode settings for the current line.
Displays the last 20 commands entered during the current CLI session.
Displays the current configuration.
Shows the line statistics.
Disables the line so data cannot be sent/received.
Enables the line so data can be sent/received.
Uses one stop bit after data on the line.
Uses two stop bits after data on the line.
5: Commands and Levels
310