Lantronix SGX 5150 Command Reference Manual page 169

priority internetwork con-
trol
priority network control
priority video
priority voice
show
show history
write
ftp (config-ftp) level commands
clrscrn
data port <number>
default data port
default passive mode
ports
default passive mode
start port
default port
exit
passive mode ports
<number>
passive mode start port
<number>
port <number>
show
show history
show statistics
state disable
state enable
write
ftp put (config-action-ftp_put:wlan0 link state change) level commands
clrscrn
connection <instance>
default mode
exit
mode sequential
mode simultaneous
no reminder interval
reminder interval
<minutes>
show
show history
write
ftp put (config-action-ftp_put:usb0 link state change) level commands
clrscrn
connection <instance>
default mode
SGX™ 5150 IoT Device Gateway Command Reference
Sets the priority to Internetwork Control. Bandwidth allocated is 5%-100%.
Sets the priority to Network Control. Bandwidth allocated is 5%-100%.
Sets the priority to Video. Bandwidth allocated is 20%-100%.
Sets the priority to Voice. Bandwidth allocated is 30%-100%.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
Clears the screen.
Sets the FTP server data-port.
Restores the FTP server data-port to default: 20.
Clears the FTP server number of passive ports.
Clears the FTP server passive mode start port.
Restores the FTP server port to default: 21.
Returns to the config level.
Sets the FTP server number of passive ports.
Sets the FTP server passive mode start port.
Sets the FTP server port.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays the FTP statistics.
Disables the FTP server.
Enables the FTP server.
Stores the current configuration in permanent memory.
Clears the screen.
Enters the next lower level. Specify the instance for the next lower level.
Sets default of simultaneous connection mode.
Exits to the next higher level.
Sets sequential mode; will stop after first connection that goes through.
Sets simultaneous mode; will make all possible connections.
Clears the FTP Put reminder interval. FTP Put is sent once only.
Sets the FTP Put reminder interval.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
Clears the screen.
Enters the next lower level. Specify the instance for the next lower level.
Sets default of simultaneous connection mode.
5: Commands and Levels
169