ikev2 insist
ikev2 never
ikev2 permit
ikev2 propose
interface <text>
local id <text>
local key length <bits>
local next hop <text>
local subnet <text>
mode configuration disa-
ble
mode configuration ena-
ble
nat traversal disable
nat traversal enable
no connection name
no local id
no local next hop
no local subnet
no password
no psk
no remote endpoint
no remote id
no remote key
no remote next hop
no remote rsa key
no remote subnet
no username
password <text>
perfect forward secrecy
disable
perfect forward secrecy
enable
psk <text>
remote endpoint <text>
remote id <text>
remote key <text>
remote next hop <text>
remote peer type cisco
remote peer type ietf
remote rsa key <text>
remote subnet <text>
sa life time <hours>
SGX™ 5150 IoT Device Gateway Command Reference
Sets the IKEv2 setting to Insist, signifying that the device will only accept and receive
IKEv2 and IKEv1 negotiations will be rejected.
Sets the IKEv2 setting to Never, signifying no IKEv2 negotiation should be transmitted or
accepted.
Sets the IKEv2 setting to Permit, signifying no IKEv2 should be transmitted, but will be ac-
cepted if the other ends initiates to us with IKEv2.
Sets the IKEv2 setting to Propose, signifying that the device will permit IKEv2, and also
use it as the default to initiate.
Sets the interface. <text> = interface.
Sets the local id. <text> = local id.
Sets the local RSA key length.
Sets the local next hop. <text> = local next hop.
Sets the local subnet. <text> = local subnet.
Disables mode configuration.
Enables mode configuration.
Disables NAT traversal.
Enables NAT traversal.
Clears the name.
Clears the local id.
Clears the local next hop.
Clears the local subnet.
Clears the password.
Clears the pre shared key.
Clears the remote end point.
Clears the remote id.
Clears the remote key.
Clears the remote next hop.
Clears the remote RSA key.
Clears the remote subnets.
Clears the username.
Sets the password. <text> = password.
Disables perfect forward secrecy (PFS).
Enables perfect forward secrecy (PFS).
Sets the pre shared key (PSK). <text> = pre shared key.
Sets the remote end point. <text> = remote end point.
Sets the remote id. <text> = remote id.
Sets the remote key. <text> = remote key.
Sets the remote next hop. <text> = remote next hop.
Sets the remote peer type to cisco.
Sets the remote peer type to ietf.
Sets the remote RSA key. <text> = remote RSA key.
Sets the remote subnets. <text> = remote subnets.
Sets the SA lifetime.
5: Commands and Levels
368
Need help?
Do you have a question about the SGX 5150 and is the answer not in the manual?