Lantronix SGX 5150 Command Reference Manual page 68

block serial enable
clrscrn
credentials <text>
default accept mode
default local port
default protocol
default start character
default tcp keep alive
default tcp keep alive
interval
default tcp keep alive
probes
email connect <number> Sets an email profile to use to send an email alert upon establishing an accept mode tun-
email disconnect <num-
ber>
exit
flush serial disable
flush serial enable
flush start character dis-
able
flush start character ena-
ble
initial send binary <bina-
ry>
initial send set <text>
kill connection
local port <number>
no aes decrypt key
no aes encrypt key
no credentials
no email connect
no email disconnect
no initial send
password
protocol ssh
protocol ssl
protocol tcp
protocol tcp aes
protocol telnet
secure protocols ssl3
disable
secure protocols ssl3
SGX™ 5150 IoT Device Gateway Command Reference
Discards all data coming in from the serial interface before forwarding it to the accept mode
tunnel (generally used for debugging).
Clears the screen.
Selects the RSA/DSA certificates by name for the SSL server.
Restores the default accept mode as 'always'.
Uses the default port number as the local port for accept mode tunneling. The default port
is 10000 + n, where 'n' is the line number for this tunnel.
Restores the default accept mode tunneling protocol as 'TCP'.
Defaults the accept mode start character.
Defaults the TCP keep alive time.
Restores the default 45 second accept mode TCP keep alive timeout.
Defaults the TCP keep alive probes.
nel. <number> = the number of the email profile to use.
Sets an email profile to use to send an email alert upon closing an accept mode tunnel.
<number> = the number of the email profile to use.
Returns to the tunnel level.
Characters already in the serial data buffer are retained upon establishing an accept mode
tunneling connection.
Flushes the serial data buffer upon establishing an accept mode tunneling connection.
Enables forwarding of the accept start character into the network.
Disables forwarding of the accept start character into the network.
Sets the accept tunnel Initial Send text allowing for binary characters. <binary> = string in
binary format that will be sent out the network upon connection. Within [] use binary deci-
mal up to 255 or hex up to 0xFF.
Sets the accept tunnel Initial Send text. <text> = ascii string that will be sent out the net-
work upon connection.
Disconnects the active accept mode tunneling connection.
Sets the port to use for accept mode tunneling. <number> = number of the port to use.
Removes the accept tunnel AES decrypt key.
Removes the accept tunnel AES encrypt key.
Clears the RSA/DSA certificate selection for the SSL server.
Discontinues sending email alerts upon establishing an accept mode tunnel.
Discontinues sending email alerts upon closing an accept mode tunnel.
Removes the accept tunnel Initial Send string.
Enters the next lower level.
Uses SSH protocol for accept mode tunneling.
Uses SSL protocol for accept mode tunneling.
Uses TCP protocol for accept mode tunneling.
Uses TCP protocol with AES encryption for accept mode tunneling.
Uses Telnet protocol (with IAC) for accept mode tunneling.
Disables the protocol.
Enables the protocol.
5: Commands and Levels
68