Lantronix SGX 5150 Command Reference Manual page 321

reboot after firmware
update enable
reboot after update disa-
ble
reboot after update ena-
ble
show
show history
show statistics
state disable
state enable
status update interval
<minutes>
write
mass storage (filesystem-mass_storage) level commands
clrscrn
exit
show
show history
usb auto mount disable
usb auto mount enable
write
modbus (modbus) level commands
additional port <number> Sets an additional TCP server port.
clrscrn
default response timeout Restores the default Modbus Response Timeout.
exit
kill connection <index>
no additional port
response timeout <milli-
seconds>
rss
show
show connections
show history
show statistics
tcp server state disable
tcp server state enable
write
modem (tunnel-modem:4) level commands
clrscrn
connect string <text>
default incoming connec-
tion
default response type
display remote ip disable The incoming RING has nothing following it.
SGX™ 5150 IoT Device Gateway Command Reference
Enables automatic reboot when new firmware is applied.
Restores the default action when new configuration is applied (do not reboot)
Enables automatic reboot when new configuration is applied.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays the MACH10 statistics.
Disables the Mach10 client.
Enables the Mach10 client.
Sets the status update interval.
Stores the current configuration in permanent memory.
Clears the screen.
Exits to the next higher level.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Disables automatic mount of connected USB drives.
Enables automatic mount of connected USB drives.
Stores the current configuration in permanent memory.
Clears the screen.
Exits to the config level.
Kills modbus connection selected by index from show connections.
Removes the additional TCP server port.
Sets the Modbus Response Timeout in milliseconds.
Enters the next lower level.
Displays the current configuration.
Displays connections.
Displays the last 20 commands entered during the current CLI session.
Displays statistics.
Disables the Modbus TCP Server.
Enables the Modbus TCP Server.
Stores the current configuration in permanent memory.
Clears the screen.
Sets the CONNECT string used in modem emulation. <string> = connect string.
Default disables incoming network connections.
Default uses text type responses.
5: Commands and Levels
321