Lantronix SGX 5150 Command Reference Manual page 316

start wps pin
status
wifi direct go mode disa-
ble
wifi direct go mode ena-
ble
write
link (config-ethernet:eth0) level commands
clrscrn
credentials <text>
default duplex
default eap-ttls option
default fast option
default fast provisioning
default ieee 802 1x
default peap option
default speed
duplex auto
duplex full
duplex half
eap-ttls option chap
eap-ttls option eap-md5
eap-ttls option eap-
mschapv2
eap-ttls option mschap
eap-ttls option mschapv2 Sets the EAP-TTLS authentication protocol option to MSCHAP V2.
eap-ttls option pap
eapol disable
eapol enable
exit
fast option gtc
fast option md5
fast option mschapv2
fast provisioning authen-
ticated
fast provisioning both
fast provisioning unau-
thenticated
ieee 802 1x eap-tls
ieee 802 1x eap-ttls
ieee 802 1x fast
ieee 802 1x peap
inner credentials <text>
no credentials
no inner credentials
no password
SGX™ 5150 IoT Device Gateway Command Reference
Starts wi-fi protected setup operation.
Show link status
Disables WiFi Direct Group Owner Mode.
Enables WiFi Direct Group Owner Mode.
Stores the current configuration in permanent memory.
Clears the screen.
Selects the RSA certificate by configured name.
Restores the default duplex setting, which is auto.
Restores the default EAP-TTLS protocol option, which is EAP-MSCHAP V2.
Restores the default FAST authentication protocol option, which is MD5.
Restores the default FAST provisioning, which is Authenticated
Restores the default IEEE 802.1x protocol, which is EAP-TTLS.
Restores the default PEAP authentication protocol option, which is EAP-MSCHAP V2.
Restores the default speed setting, which is auto-negotiate.
Sets duplex mode to auto.
Sets duplex mode to full.
Sets duplex mode to half.
Sets the EAP-TTLS authentication protocol option to CHAP.
Sets the EAP-TTLS authentication protocol option to EAP-MD5.
Sets the EAP-TTLS authentication protocol option to EAP-MSCHAP V2.
Sets the EAP-TTLS authentication protocol option to MSCHAP.
Sets the EAP-TTLS authentication protocol option to PAP.
Disables EAPoL Authentication.
Enables EAPoL Authentication
Exit back to interface configuration level
Sets the FAST authentication protocol option to GTC.
Sets the FAST authentication protocol option to MD5.
Sets the FAST authentication protocol option to MSCHAPv2.
Sets the FAST provisioning option to Authenticated.
Sets the FAST provisioning option to Both.
Sets the FAST provisioning option to Unauthenticated.
Sets the IEEE 802.1x protocol to EAP-TLS.
Sets the IEEE 802.1x protocol to EAP-TTLS.
Sets the IEEE 802.1x protocol to FAST.
Sets the IEEE 802.1x protocol to PEAP.
Selects the RSA certificate by configured name.
Clears the RSA certificate name.
Clears the RSA certificate name.
Clears the password.
5: Commands and Levels
316