Lantronix SGX 5150 Command Reference Manual page 315

show history
state disable
state enable
status update interval
<minutes>
write
link (config-wlan:wlan0) level commands
antenna diversity anten-
na 1
antenna diversity anten-
na 2
antenna diversity ena-
bled
apply wlan
band 2.4 ghz only
band 5 ghz only
band auto
cancel wps
choice <instance>
clrscrn
debugging level debug
debugging level dump
debugging level error
debugging level info
debugging level warning Sets the WLAN debugging level to Warning.
default antenna diversity Restore the default value for antenna diversity.
default band
default debugging level
default scanning latency Restores scanning latency to the default value (Standard).
exit
no scanning channel list Clears the scanning channel list.
scan <ssid>
scanning channel list
<text>
scanning latency en-
hanced throughput
scanning latency stand-
ard
show
show history
show wps information
show wps information
with secrets
show wps status
smartroam
start wps
SGX™ 5150 IoT Device Gateway Command Reference
Displays the last 20 commands entered during the current CLI session.
Disables command processing on line.
Enables command processing on line.
Sets the status update interval.
Stores the current configuration in permanent memory.
Set antenna selection to 1
Set antenna selection to 2
Set antenna diversity to enabled.
Try out WLAN settings without saving them to Flash. If the settings do not work, when you
reboot the device, it will still have the original settings.
Sets the radio band to 2.4 GHz only.
Sets the radio band to 5 GHz only.
Sets the radio band to Auto.
Cancels wi-fi protected setup operation.
Enters the next lower level. Specify the instance for the next lower level.
Clears the screen.
Sets the WLAN debugging level to Debug.
Sets the WLAN debugging level to Dump, the most verbose option.
Sets the WLAN debugging level to Error, which shows only errors.
Sets the WLAN debugging level to Info.
Restores the radio band to the default value (Auto).
Sets the WLAN debugging level to its default value, Info.
Exit back to interface configuration level
Scan the radio environment for networks.
Sets the scanning channel list.
Sets scanning latency to Enhanced Throughput.
Sets scanning latency to Standard.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Show the configuration received by wi-fi protected setup.
Show the configuration received by wi-fi protected setup with secrets.
Show status of WPS operation.
Enter smartroam configuration level
Starts wi-fi protected setup operation.
5: Commands and Levels
315