Lantronix SGX 5150 Command Reference Manual page 325

email
exit
ftp put
http post
show
show history
show status
snmp trap
write
packing (tunnel-packing:4) level commands
clrscrn
default packing mode
default send character
default threshold
default timeout
exit
no trailing character
packing mode disable
packing mode send
character
packing mode timeout
send character <control> Sets the send character for packing mode. The character may be input as text, control,
show
show history
threshold <bytes>
timeout <milliseconds>
trailing character <con-
trol>
write
packing (tunnel-packing:3) level commands
clrscrn
default packing mode
default send character
default threshold
default timeout
exit
no trailing character
packing mode disable
packing mode send
character
packing mode timeout
SGX™ 5150 IoT Device Gateway Command Reference
Enters the next lower level.
Exits to the config alarm level.
Enters the next lower level.
Enters the next lower level.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays statistics.
Enters the next lower level.
Stores the current configuration in permanent memory.
Clears the screen.
Sets to default packing mode, which is 'Disable'
Removes the send character for packing mode.
Restores the default threshold.
Restores the default packing mode timeout.
Returns to the tunnel level.
Removes the trailing character for packing mode.
Disables packing. Data is sent to the network when received.
Sets packing mode to accumulate data and transmit it upon receiving the configured send
character on the line (serial port).
Sets packing mode to accumulate data and transmit it after a specified amount of time
(timeout).
decimal, or hex. A control character has the form <control>C. A decimal value character
has the form \99. A hex value character has the form 0xFF.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Sets the threshold (byte count). If the queued data reaches this threshold then the data will
be sent. <bytes> = number of bytes in the threshold.
Sets the timeout value for packing mode in milliseconds. <milliseconds> = timeout value, in
milliseconds.
Sets the trailing character for packing mode. The character may be input as text, control,
decimal, or hex. A control character has the form <control>C. A decimal value character
has the form \99. A hex value character has the form 0xFF.
Stores the current configuration in permanent memory.
Clears the screen.
Sets to default packing mode, which is 'Disable'
Removes the send character for packing mode.
Restores the default threshold.
Restores the default packing mode timeout.
Returns to the tunnel level.
Removes the trailing character for packing mode.
Disables packing. Data is sent to the network when received.
Sets packing mode to accumulate data and transmit it upon receiving the configured send
character on the line (serial port).
Sets packing mode to accumulate data and transmit it after a specified amount of time
5: Commands and Levels
325