Lantronix SGX 5150 Command Reference Manual page 86

no email disconnect
promote host <number> Promotes the identified host, exchanging it place with the host above it, to adjust the order
reconnect time <millisec-
onds>
show
show history
show status
start character <control> Sets the connect mode start character. The character may be input as text, control, deci-
write
connection 1 (config-mach10-connection:1) level commands
clrscrn
default host
default local port
default mqtt host
default mqtt local port
default mqtt port
default port
default proxy port
default proxy type
exit
host <text>
local port <number>
mqtt host <text>
mqtt local port <number> Sets the local port for Mach10 MQTT client. When configured, a total of 32 consecutive
mqtt port <number>
mqtt security disable
mqtt security enable
mqtt state disable
mqtt state enable
no proxy host
no proxy password
no proxy username
port <number>
proxy host <text>
proxy password <text>
proxy port <number>
proxy type socks5
proxy username <text>
secure port disable
secure port enable
show
SGX™ 5150 IoT Device Gateway Command Reference
Discontinues sending email alerts upon closing a connect mode tunnel.
of the defined hosts.
Sets the reconnect time value for tunneling connections established by the device in milli-
seconds. <milliseconds> = timeout in milliseconds.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays tunnel connect status.
mal, or hex. A control character has the form <control>C. A decimal value character has
the form \99. A hex value character has the form 0xFF.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the Hostname or IP address of Mach 10.
Clears the local port for Mach10 client.
Restores the Hostname or IP address of MQTT server.
Clears the local port for Mach10 MQTT client.
Restores the Port of MQTT server.
Restores the Port of Mach 10.
Restores the Port of proxy server.
Restores the default Proxy server type (SOCKS5).
Exits to the next higher level.
Sets the Hostname or IP address of Mach 10.
Sets the local port for Mach10 client. When configured, a total of 16 consecutive ports will
be reserved.
Sets the Hostname or IP address of MQTT server.
ports will be reserved.
Sets the Port of MQTT server.
Disables SSL for MQTT.
Enables SSL for MQTT.
Disables MQTT.
Enables MQTT.
Restores the Hostname or IP address of the proxy server.
Restores the password for proxy server.
Clears the user name for the proxy server.
Sets the Port of Mach 10.
Sets the Hostname or IP address of the proxy server.
Sets the password the proxy server.
Sets the Port of the proxy server.
Sets the Proxy server type to SOCKS5
Sets the user name for the proxy server.
Disables HTTPS for Mach10 client.
Enables HTTPS for Mach10 client.
Shows the current configuration.
5: Commands and Levels
86