Lantronix SGX 5150 Command Reference Manual page 297

ipv6 state enable
link
mtu <bytes>
no default gateway
no dhcp client id
no domain
no hostname
no ip address
no ipv6 address
no ipv6 default gateway
no ipv6 domain
no ipv6 primary dns
no ipv6 secondary dns
no primary dns
no secondary dns
primary dns <IP ad-
dress>
priority <number>
qos
secondary dns <IP ad-
dress>
show
show history
show status
state disable
state enable
write
if 3 (config-if:usb0) level commands
clrscrn
default gateway <IP ad-
dress>
default mtu
default priority
dhcp client id <text>
dhcp disable
dhcp enable
dhcp renew
domain <text>
exit
failover
hostname <text>
if <instance>
ip address <ip ad-
dress/cidr>
SGX™ 5150 IoT Device Gateway Command Reference
notation. A network is denoted by the first address in the block (ending in all zeroes), a
slash (/), and a decimal value equal to the size in bits of the prefix
Enables IPv6 for the interface.
Enter link configuration level
Sets the Maximum Transmission Unit (MTU) size.
Clears the default gateway.
Clears the DHCP client ID.
Clears the domain name.
Clears the host name.
Clears the IP address.
Clears the IPv6 static address.
Clears the IPv6 default gateway.
Clears the IPv6 domain name.
Clears the IPv6 address of the primary DNS server.
Clears the IPv6 address of the secondary DNS server.
Clears the name of the primary DNS server.
Clears the name of the secondary DNS server.
Sets the IP address of the primary DNS server.
Sets the priority for interface. <number> = priority number.
Enter QoS configuration level
Sets the IP address of the secondary DNS server.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Show interface status
Disables the interface.
Enables the interface.
Stores the current configuration in permanent memory.
Clears the screen.
Sets the configurable gateway IP address to the default value.
Restores the default Maximum Transmission Unit (MTU) size.
Restores the default priority for the interface.
Sets the DHCP client ID.
Disables DHCP.
Enables DHCP.
Force DHCP to renew
Sets the domain name. <text> = name of the domain.
Exits to the config level.
Enter failover configuration level
Sets the host name. <text> = name of the host.
Changes to the interface configuration level.
Sets the IP address and network mask. Formats accepted: 192.168.1.1 (default mask)
192.168.1.1/24 (CIDR) "192.168.1.1 255.255.255.0" (explicit mask)
5: Commands and Levels
297