Lantronix SGX 5150 Command Reference Manual page 77

state disable
state enable
terminal <line>
terminal network
threshold <bytes>
tunnel <line>
usb <line>
write
bridge 1 (config-bridge:br0) level commands
auto detect ip address
disable
auto detect ip address
enable
bridging initial scan inter-
val <seconds>
bridging ip address <IP
address>
bridging ipv6 address
<ipv6 address>
bridging mode host
bridging mode network
bridging mode static net-
work
bridging scan interval
<seconds>
clrscrn
default bridging initial
scan interval
default bridging mode
default bridging scan
interval
default ethernet interface Restores the default Bridging ethernet interface.
ethernet interface <text> Sets the Bridging ethernet interface.
exit
network access for gate-
way disable
network access for gate-
way enable
no bridging ip address
no bridging ipv6 address Removes the Bridging IPv6 Address.
no bridging mac address Removes the Bridging MAC Address.
show
show history
show statistics
SGX™ 5150 IoT Device Gateway Command Reference
Disables the line so data cannot be sent/received.
Enables the line so data can be sent/received.
Enters the configure-terminal level. <line> = number of the terminal line (serial port) to be
configured.
Enters the configure-terminal level for the network.
Sets the threshold in bytes. After this many bytes are received, they are forwarded without
delay.
Enters the tunnel level. <line> = number of the tunnel line (serial port) to be configured.
Enters the usb level. <line> = number of the line (usb port) to be configured.
Stores the current configuration in permanent memory.
Disables learning the IPv4 address of the bridged client.
Enables learning the IPv4 address of the bridged client.
Sets the scan interval before learning the IP address of the bridged client.
Sets the Bridging IP Address.
Sets the Bridging IPv6 Address. IPv6 addresses are written in eight groups of four hexa-
decimal digits separated by colons, such as 2001:0db8:85a3:0000:0000:8a2e:0370:7334
Network address ranges are written in CIDR notation. A network is denoted by the first
address in the block (ending in all zeroes), a slash (/), and a decimal value equal to the
size in bits of the prefix
Sets the bridging mode to 'Host'.
Sets the bridging mode to 'Network'.
Sets the bridging mode to 'Static Network'.
Sets the scan interval after learning the IP address of the bridged client.
Clears the screen.
Restores the default initial scan interval.
Restores the default bridging mode.
Restores the default scan interval.
Exits to the config level.
Disables network access for gateway in transparent bridging mode.
Enables network access for gateway in transparent bridging mode.
Removes the Bridging MAC Address.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Show bridge statistics
5: Commands and Levels
77