Lantronix SGX 5150 Command Reference Manual page 73

protocol telnet
secure protocols ssl3
disable
secure protocols ssl3
enable
secure protocols tls1.0
disable
secure protocols tls1.0
enable
secure protocols tls1.1
disable
secure protocols tls1.1
enable
secure protocols tls1.2
disable
secure protocols tls1.2
enable
show
show history
show status
start character <control> Sets the accept mode start character. The character may be input as text, control, decimal,
tcp keep alive <millisec-
onds>
tcp keep alive interval
<milliseconds>
tcp keep alive probes
<number>
write
access point (config-access-point) level commands
channel <number>
channel selection auto-
matic
channel selection config-
ured
clrscrn
default channel
default channel selection Sets to default channel selection, which is 'Automatic'.
default first client connect
timeout
default ip address
default last client discon-
nect timeout
default mode
default suite
dns redirect <text>
exit
first client connect
timeout <seconds>
SGX™ 5150 IoT Device Gateway Command Reference
Uses Telnet protocol (with IAC) for accept mode tunneling.
Disables the protocol.
Enables the protocol.
Disables the protocol.
Enables the protocol.
Disables the protocol.
Enables the protocol.
Disables the protocol.
Enables the protocol.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Displays tunnel accept status.
or hex. A control character has the form <control>C. A decimal value character has the
form \99. A hex value character has the form 0xFF.
Sets the TCP keep alive time. This is the initial keep alive timeout. <milliseconds> = timer
value, in milliseconds.
Enables TCP keep alive for accept mode tunneling and sets the timer. <milliseconds> =
TCP keep alive for accept mode in milliseconds.
Sets the number of TCP keep alive probes. <number> = number of TCP keep alive probes.
Stores the current configuration in permanent memory.
Sets the channel on which the Access Point will operate.
Sets channel selection to automatic.
Sets channel selection to configured.
Clears the screen.
Clears the Access Point channel setting.
Sets default First Client Connect Timeout for SoftAP trigger mode.
Restores IP address of Access Point to the default value.
Sets default Last Client Disconnect Timeout for SoftAP trigger mode.
Restores the AP mode to the default value (Always Up).
Restores the security method (suite) to the default value (None).
Set the DNS redirect. <text> = Hostname.
Returns to the config level.
Sets the First Client Connect Timeout for SoftAP trigger mode in seconds.
5: Commands and Levels
73