Lantronix SGX 5150 Command Reference Manual page 328

write
password (tunnel-accept-password:1) level commands
clrscrn
exit
no password
password <text>
prompt disable
prompt enable
show
show history
write
port forwarding rule 1 (config-portforwarding:1) level commands
clrscrn
default protocol
exit
friendly name <text>
ingress ip address <text> Sets the original WAN destination IP address for port forwarding rule.
ip address <text>
no friendly name
no ingress ip address
no ip address
no port or range
no target port
port forwarding rule
<number>
port or range <text>
protocol both
protocol tcp
protocol udp
show
show history
state disable
state enable
target port <text>
write
port forwarding rule 2 (config-portforwarding:2) level commands
clrscrn
default protocol
exit
friendly name <text>
ingress ip address <text> Sets the original WAN destination IP address for port forwarding rule.
ip address <text>
no friendly name
no ingress ip address
no ip address
SGX™ 5150 IoT Device Gateway Command Reference
Stores the current configuration in permanent memory.
Clears the screen.
Exits to the next higher level.
Removes the password so connections will be accepted unchallenged.
Sets the password required on the network side of the tunnel to begin a connection.
Inhibits any prompting for password on the network side of the tunnel.
Sets up so a user on the network side of the tunnel will be prompted for a password.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI session.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the default value of the protocol (Both).
Exits to the config-gateway level.
Set the friendly name for port forwarding rule <text> = friendly name
Sets the LAN destination IP address for port forwarding rule.
Remove the friendly name.
Clears the original WAN destination IP address for port forwarding rule.
Clears the LAN destination IP address for port forwarding rule.
Clears the WAN port or range for port forwarding rule.
Clears the LAN destination port for port forwarding rule.
Change to config gateway port forwarding level.
Sets the WAN port or range for port forwarding rule. <text> = port or range.
Sets the protocol to Both (TCP and UDP).
Sets the protocol to TCP.
Sets the protocol to UDP.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI session.
Disables the port forwarding rule.
Enables the port forwarding rule.
Sets the LAN destination port for port forwarding rule. <text> = port.
Stores the current configuration in permanent memory.
Clears the screen.
Restores the default value of the protocol (Both).
Exits to the config-gateway level.
Set the friendly name for port forwarding rule <text> = friendly name
Sets the LAN destination IP address for port forwarding rule.
Remove the friendly name.
Clears the original WAN destination IP address for port forwarding rule.
Clears the LAN destination IP address for port forwarding rule.
5: Commands and Levels
328