Initial Setup; Connect Via Usb; Cable For Usb Activesync Connection - Honeywell Thor VM2 User Manual

Because ActiveSync is already installed on your device, your first synchronization pro-
cess begins automatically when you finish setting up your desktop computer in the
ActiveSync wizard. For more information about using ActiveSync on your desktop com-
puter, open ActiveSync, then open ActiveSync Help.

Initial Setup

The initial setup of ActiveSync must be made via a USB connection. When there is a
Connect icon on the desktop, this section can be bypassed. Partnerships can only be
created using USB cable connection.

Connect via USB

The default connection type is USB Client
This is the only connection option supported on the Thor VM2.
To verify it is set to USB, select
Start > Settings > Control Panel > PC Connection
Tap the Change button. From the popup list, choose
USB Client
This will set up the mobile device to use the USB port. Tap OK and ensure the check box
for "Allow connection with desktop computer when device is attached" is checked.
Tap OK to return to the Control Panel. If desired, any control panel windows may be
closed.
Connect the USB cable to the PC (the host) and the mobile device (the client) as
detailed below. USB will start automatically when the USB cable is connected, not
requiring you to select "Connect" from the start menu.
When the Thor VM2 loses connection, e.g. enters Suspend Mode, etc., the connection to
ActiveSync will be lost. When the Thor VM2 resumes, the ActiveSync session will auto-
matically re-connect.

Cable for USB ActiveSync Connection:

VM1052CABLE - Thor VM2 Dongle cable provides USB type A connector.
•
•
•
270
D9 connector connects to the USB port on the Thor VM2 dock.
The USB type A client connector on cable connects to a USB port on a PC or laptop.
The USB host connector on the dongle cable does not need to be connected.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide