Initial Setup For Thor Vm1; Hardware Setup; Software - Honeywell THOR VM1 User Manual

If you ordered additional accessories for the Thor VM1, verify they are also included with the order. Keep the original packaging
material in the event the Thor VM1 should need to be returned for service. For details, see
1).

Initial Setup for Thor VM1

This page lists a quick outline of the steps you might take when setting up a new Thor VM1. More instruction for each step is
listed later in this guide.
Contact Technical Assistance

Hardware Setup

1. Install RAM Mount
2. Place Thor VM1 in the Dock
3. Connect Cables (page 4-29) for any peripherals.
4. Connect Power (page 4-30).
5. Secure all cables in
6. Press the Power Switch
7. Press the Power Button

Software

Languages
The Thor VM1 may be shipped with an English only operating system. Contact
order a Thor VM1 Recovery DVD
ware tab of the About
First Boot
When a new Thor VM1 starts up a EULA (End User License Agreement) may be displayed on the touch screen. It
remains on the screen until the Accept or Decline button is tapped with a stylus.
Tap the Accept button to accept the EULA terms and the Thor VM1 continues the startup process. The EULA is not
presented to the user again.
Tap the Decline button to decline the EULA and the Thor VM1 reboots. It will continue to reboot until the Accept button
is tapped with the stylus.
Software Setup
Hardware setup should be completed before starting software setup.
2 - 2
(page 9-1) if you need additional help.
(page 4-20) or Install U Bracket Mount
(page 4-18).
Strain Relief Cable Clamps
(page 3-5) on the dock to the on position.
(page 3-5) on the Thor VM1.
(page 5-27) in a different language. The language installed is identified on the Soft-
(page 5-3) control panel.
(page 4-26) to the vehicle.
(page 4-29).
Product Service and Repair
Technical Assistance (page 9-1) to
(page 9-