External Connectors; Serial Connector (Com1 And Com2) - Honeywell Thor VM2 User Manual

External Connectors

Power the Thor VM2 off before attaching a cable to any port (serial, USB, Audio/CAN,
etc.).
The external I/O connectors for the Thor VM2 are located on the right side of the dock
(when viewed from the back).
The
Antenna connectors are located on the top rear of the Thor VM2.

Serial Connector (COM1 and COM2)

Standard Dock
Screen Blanking
The screen blanking signal can be provided either by a Honeywell Screen Blanking Box
or a user supplied switch or relay. See
screen blanking accessories.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Power Supply Connector
COM1
COM2
USB
CANBUS/AUDIO
is on the left side of the dock (when viewed from the back).
Enhanced Dock
Screen Blanking
The COM1 and COM2 connectors
are D-9 male connectors located on
the back of the dock.
Power the Thor VM2 off before
attaching a cable to any port (serial,
USB, Audio/CAN, etc.).
The serial connectors are industry-
standard RS-232, PC/AT standard
9–pin "D" male connector. See
COM1 and COM2 Connector
connector pinout detail.
By default, Pin 9 is configured to
provide +5V for an external bar code
scanner. Pin 9 of COM1 or COM2
may also be configured to provide
RI.
See Connect Serial Device
information.
If a COM port is not being used for a
scanner, it can be used for
Blanking when the vehicle is in
motion.
for information on connecting
for
for more
Screen
35