Install Sim Card; Equipment Required; Installation Procedure - Honeywell Thor VM2 User Manual

Install SIM Card

A SIM card may be required for WWAN.
Note: The SIM card is not hot-swappable. After installing or removing a SIM card, the Thor VM2
must be rebooted for the change to take effect.

Equipment Required

The following equipment is user-supplied:
•
•
•

Installation Procedure

1. For convenience, the Thor VM2
2. If the Thor VM2 remains in the
3. Place the Thor VM2 in Suspend by
4. Place the Thor VM2 face down on a
5. Using a #2 Phillips bit loosen the
6. Locate the SIM card installation slot, as highlighted to the right.
7. Slide the SIM card into the slot.
Note: The entire SIM slot is not visible due to the design of the Thor VM2 case. However, the
entire slot is shown below to help with installation.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
SIM card for desired carrier
Torquing tool capable of measuring inch pounds
#2 Phillips screwdriver bit
can be removed from the dock,
though it is not necessary.
dock, disconnect the power cable
from the dock.
pressing the Power button.
stable surface.
M3 screws and then remove the
tethered access panel with the SIM
label. This panel is on the right hand side when the Thor VM2 is face down with the
top away from the user.
129