Password
Start > Settings > Control Panel > Password
Use this panel to set Thor VM2 user access to control panels and power up password
properties.
Important: This password must be entered before performing a Load Factory Defaults.
If entering a power-on or screen saver password does not allow you to disable this pass-
word protection or perform a Load Factory Defaults, contact
Factory Default Settings
Password
Enter password at Power On
Enter password at Remote Desktop Screen Saver
•
•
•
•
•
•
Enter the password in the Password text box, then press Tab and type the password
again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox.
A changed/saved password is in effect immediately.
Use this panel to set Thor VM2 user access to control panels and power up password
properties.
Important: This password must be entered before performing a Load Factory Defaults.
232
The password and password settings are saved during a warm boot and a restart.
The screensaver password affects the Remote Desktop screensaver only.
After a password is assigned and saved, each time a Settings > Control Panel option
is selected, the user will be required to enter the password before the Control Panel
will open.
The screensaver password is the same as the power-on password. They are not set
independently.
A screensaver password cannot be created without first enabling the "Enable
password protection at power-on" checkbox.
The screensaver password is not automatically enabled when the "power-on"
checkbox is enabled.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Technical
Blank
Disabled
Disabled
Assistance.