Hsm Connect; Installation - Honeywell Thor VM2 User Manual

One or more control lines are tied together incorrectly. This is usually a cable problem.
ActiveSync indicator on the host turns green and spins, but connection never occurs
Check that the correct connection is selected.
-or-
Incorrect or broken data lines in cable.
ActiveSync indicator on the host remains gray
Solution 1: ActiveSync icon on the PC does not turn green after connecting USB cable
from Thor VM2.
1. Disconnect Thor VM2 USB cable from PC.
2. Suspend/Resume or Restart the Thor VM2.
3. In ActiveSync > File > Connection Settings on PC disable Allow USB Connections and
4. Re-enable Allow USB Connections on the PC and click OK.
5. Reconnect USB cable from Thor VM2 to PC.
Solution 2: The host doesn't know you are trying to connect. May mean a bad cable, with
no control lines connected, or an incompatible baud rate. Try the connection again, with
a known good cable.

HSM Connect

HSM Connect allows a user to view the Thor VM2 screen remotely from a PC using an
ActiveSync connection.
Requirement: ActiveSync version 4.5 (or higher) must be resident on a Windows XP
(desktop/laptop) host computer. Windows Mobile Device Center (version 6.1 or higher)
is required for a Windows Vista/Windows 7 desktop/laptop computer.
Note: For readability in this section, ActiveSync will be used in instructions and explanations. If
you have a Windows Vista or Windows 7 operating system on your desktop/laptop, replace
ActiveSync with Windows Mobile Device Center.
ActiveSync is already installed on the Thor VM2. The Thor VM2 is preconfigured to
establish a USB ActiveSync connection to a host PC when the USB cable is attached to
the Thor VM2 and the host PC.

Installation

1. Connect the Thor VM2 to the PC using the proper connection cable.
2. If using ActiveSync, select Explore.
3. If using Windows Mobile Device Center, select File Management > Browse the
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
click OK.
contents of your device.
273