Gobi Connection Manager - Honeywell Thor VM2 User Manual

Gobi Connection Manager

Start > Settings > Control Panel > Gobi Connection Manager or
Tap the Gobi Connection Manager Desktop Icon or
Tap the Gobi Connection Manager icon in the system tray or
Tap Start > Programs > GobiCM > GobiCMExe
Set parameters for optional internal WWAN module.
Home
CDMA
UTMS
GPS
Admin
About
The Gobi Connection Manager tray icon indicates the status of the connection in dark
blue bars. If you hover the mouse pointer over the Connection Manager Taskbar icon,
the current signal level and radio interface are displayed.
Note: The similar Summit Wi-Fi icon in the task bar uses red, yellow and green bars.
Initial Use
Some carriers such as AT&T and T-Mobile require a SIM card for use on their networks.
Other carriers such as Verizon use a CDMA network and must be activated. Please refer
to the sections below for more details.
SIM Card Installation
Depending on the carrier, a SIM card may be necessary for WWAN connection. To install
a SIM card:
1. Place the Thor VM2 in Suspend.
2. Remove the Thor VM2 from the dock.
3. Place the Thor VM2 face down on a stable surface.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
View connection status and select firmware.
Use this tab to activate a CDMA carrier such as
Verizon.
Use this tab to test and save connection parameters.
View GPS statistics.
Enter PIN or PUK for SIM card.
View information on the WWAN card.
There is no WWAN connection present.
-105 dBm to -86 dBm signal strength
-85 dBm to -66 dBm signal strength
-65 dBm to -46 dBm signal strength
-45 dBm or higher signal strength
209