Initial Setup For Thor Vm1; Hardware Setup; Software - Honeywell Thor VM1 User Manual

Initial Setup for Thor VM1

This page lists a quick outline of the steps you might take when setting up a new Thor
VM1. More instruction for each step is listed later in this guide.
Contact

Hardware Setup

Caution: If the Thor VM1 has connectors for external antennas, do not
1.
2.
3.
4.
5. Secure all cables in
6. Press the
7. Press the
Note: After the initial power on, the Thor VM1 can be configured to automatically power

Software

Languages
The Thor VM1 may be shipped with an English only operating system. Contact
Technical Assistance
guage installed is identified on the Software tab of the
First Boot
When a new Thor VM1 starts up a EULA (End User License Agreement) may be dis-
played on the touch screen. It remains on the screen until the Accept or Decline button
is tapped with a stylus.
Tap the Accept button to accept the EULA terms and the Thor VM1 continues the
startup process. The EULA is not presented to the user again.
Tap the Decline button to decline the EULA and the Thor VM1 reboots. It will continue
to reboot until the Accept button is tapped with the stylus.
Software Setup
Hardware setup should be completed before starting software setup.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Technical Assistance
power up the Thor VM1 without the external antennas
connected. Damage to the WLAN radio may result.
Install RAM Mount or
Place Thor VM1 in the
Connect Cables for any peripherals.
Connect Power.
Strain Relief Cable
Power Switch
Power Button
on, either when power is attached or the vehicle ignition is turned on.
to order a
if you need additional help.
Install U Bracket Mount
Dock.
Clamps.
on the dock to the on position.
on the Thor VM1.
Thor VM1 Recovery DVD
to the vehicle.
in a different language. The lan-
About control panel.
5