Honeywell Thor VM2 User Manual page 383

Message
Shift pressed
Shift
Show taskbar
Switching to admin-
backdoor
Switching to admin-
hotkey press
Switching to admin-
kbdhook.dll not found
Switching to admin-
keyboard hook
initialization failure
Switching to admin-
registry read failure
Switching to
TaskbarScreenMode
Switching to user mode
Switching to user-
hotkey press
Taskbar hook failure
Taskbar hook OK
Timeout looking for app
window
ToUser after admin, not
at boot
ToUser after admin-app
still open
ToUser after admin-no
app or cmd line change
Unable to move desktop
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Explanation and/or corrective action
The Shift key has been pressed and trapped by the HotKey
processing.
Processing the hotkey and backdoor entry
The taskbar is now being made visible and enabled.
The system is currently in user mode and is now switching to
admin mode. The switch occurred because of the backdoor
key presses were entered by the administrator.
The system is currently in user mode and is now switching to
admin mode. The switch occurred because of a hotkey press
by the administrator.
The keyboard hook load failed, so AppLock switches to admin
mode. If a password is specified, the password prompt is
displayed and remains until a valid password is entered.
If the keyboard hook initialization fails, AppLock switches to
admin mode. If a password is specified, the password prompt
is displayed and remains until a valid password is entered.
See the explanation of the "Registry read failure" above.
AppLock is switching into Admin mode. If a password has
been configured, the prompt will be displayed and will not be
dismissed until a valid password is entered.
In administration mode, the taskbar is visible and enabled.
The registry was successfully read and AppLock is starting
the process to switch to user mode.
The system is currently in admin mode and is now switching
to user mode. The switch occurred because of a hotkey press
by the administrator.
AppLock is unable to control the taskbar to prevent the locked
application from re-enabling it.
AppLock successfully installed control of the taskbar.
After the application is launched, AppLock must wait until the
application has initialized itself before proceeding. The
application did not start successfully and AppLock has timed
out.
The user mode switch is attempted when the device boots
and after the administrator presses the hotkey. The mode
switch is being attempted after a hotkey press.
The switch to user mode is being made via a hotkey press and
the administrator has left the application open and has not
made any changes in the configuration.
If user mode is being entered via a hotkey press, the
administrator may have left the configured application open.
If so, AppLock does not launch the application again unless a
new application or command line has been specified;
otherwise, it just locks it.
The desktop is moved when switching into user mode. This
prevents them from being visible if the application is exited
and restarted by the timer. This error does not affect the
screen mode switch; processing continues.
Level
LOG_EX
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR
371