Factory Default Settings
Enable buffered key
output
Same buffer limit
(characters)
Delay between (key)
buffers
Note: Settings on this panel have no effect when RFTerm is the application with the input focus.
Enable buffered key output
Default is enabled (checked). Click the checkbox to turn off buffered key output.
Same buffer limit
Default is 32 ms. Raise or lower this value as desired.
Delay between (key) buffers
Specifies the number of milliseconds to delay after each character in the scanned bar
code is processed as a keystroke. This value may need to be adjusted depending on the
network traffic in the environment. The default value is 75 ms. Valid value is from 0 to
9999. A zero value is No Delay between characters.
About
Start > Settings > Control Panel > Data Collection > About tab
This tab displays the Data Collection Wedge driver version installed in the Thor VM2.
The version number shown in the image below is used only as an example, your version
number will be different.
202
Enabled
32
75 ms
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide