Honeywell Thor VM2 User Manual page 95

Auto-On Control Wiring Diagram
Auto-On power mode must be selected on the
The vehicle supply connections should be made to vehicle switched power to allow the
terminal to automatically power-up when vehicle power is switched on or when the
power switch on the back of the dock is placed in the On position. The Ignition wire is
not used and should be left disconnected.
Existing Circuitry On Vehicle
Fuse - See
Warning
statement below
Caution: For battery powered vehicles:
•
•
•
Caution: For internal combustion engine powered vehicles:
•
•
•
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Battery
Main Switch
+Vo -Vo
See Caution statement below
Red wire is connected to battery positive. If there is a red wire and a red/white wire,
twist them together and connect to battery positive.
Black wire must be connected to battery negative. If there is a black wire and a black/
white wire, twist them together and connect to battery negative.
Green wire must be connected to the vehicle chassis ground.
Red wire is connected to battery positive. If there is a red wire and a red/white wire,
twist them together and connect to battery positive.
Black wire must be connected to battery negative. If there is a black wire and a black/
white wire, twist them together and connect to battery negative.
Green wire is connected to the vehicle chassis ground, which can also be battery
negative.
Power Configuration Mode
Cable for optional
screen blanking
connection
Red/White (if present)
Red
Black/White (if present)
Black
Green
Blue
(not connected)
control panel.
Quick Mount
Smart Dock
COM1 or COM2
Connector
Circular
Power
Connector
.
83