Honeywell Thor VM2 User Manual page 90
Vehicle-mounted computer with microsoft windows embedded ce 6.0
Hide thumbs
Also See for Thor VM2:
- User manual (366 pages) ,
- Reference manual (196 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
Power Cable Routing
Power cable with right-angle connector
12-48 VDC Vehicles (10-60 VDC Direct Connection)
Caution: For installation by trained service personnel only.
Caution: Use caution when routing the power cable. See
Caution: These instructions for use with
Fuse Requirements
Warning: For proper and safe installation, the input power cable must be
•
•
78
Cautions.
Enhanced Dock
connected to a fused circuit on the vehicle. If the supply
connection is made directly to the battery, the fuse should be
installed in the positive lead within 5 inches of the battery's
positive (+) terminal. Use VM3055FUSE (or equivalent) to
install the fuse as shown below:
For 12VDC input, use the 10A fuse from the kit or a slow blow fuse that has a DC
voltage rating greater than 12VDC.
For 24VDC input, use the 6A fuse from the kit or a slow blow fuse that has a DC
voltage rating greater than 24VDC.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Power cable with straight connector
VM1D Standard Dock
only.
Avoid sharp bends in this
area of the power cable
Power Cable
and
VM3D
Advertisement
Table of Contents
