Honeywell Thor VM2 User Manual page 222

4. Use a Phillips screwdriver (not supplied) loosen the screws and then remove the
5. Install the SIM card in the slot.
6. Reattach the access panel, torquing the screws to 4 to 5 inch pounds.
7. Reinstall the Thor VM2 in the dock.
8. Resume the Thor VM2 from suspend.
9. If the SIM card requires a PIN or PUK, a warning message may be displayed. Dismiss
Activate
To activate service for a CDMA carrier such as Verizon, complete the necessary entries
on the
Home
Use the Home tab to update firmware and view the status of the connection.
To select a network/update firmware:
1. Select the desired carrier from the Network Selection (previously labeled Firmware
2. If no firmware files are found, an error message is displayed. Contact
3. Tap the Apply (formerly labeled Update Firmware) button.
4. The update process may take a minute or so to complete.
The status of the Gobi 3000 radio is displayed in the lower left corner of this tab. An
error message is displayed in this location if the firmware selected requires a SIM card
and no SIM card is installed in the Thor VM2.
Connection status is at the top of this tab.
210
tethered access panel with the SIM label. This panel is on the right hand side when
the Thor VM2 is face down with the top away from the user.
the warning message and enter the PIN or PUK on the
CDMA tab.
Selection) pull-down list.
Assistance for information.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Admin tab.
Technical