Honeywell Thor VM2 User Manual page 99

60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid)
These instructions are for use with
Enhanced Dock
This option requires DC/DC external power supply Honeywell Part no. 9000313PWR-
SPLY.
Shown With Lid Attached
•
If the DC/DC power supply does not have screws in the side of the lid, see
Vehicles (50-150 VDC Power Supply, Screws on Top of
Caution: For installation by trained service personnel only.
Caution: Usage in areas where moisture can affect the power supply
Caution: Use caution when routing the power cable. See
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
only.
Lid is secured with screws on the
side of lid.
connections should be avoided. The power supply should be
mounted in a dry location within the vehicle or placed in a
suitable protective enclosure.
Cautions.
VM1D Standard Dock
Shown With Lid Removed
• Input and output connector blocks
under lid.
• One positive (Vin+), negative (Vin-)
and ground (
input block.
• One positive (Vo+) and negative
(Vo-) connection in output block.
Lid).
and VM3D
) connection in
60-144 VDC
Power Cable
87