Initial Setup For Thor Vm3; Hardware Setup; Software - Honeywell Thor VM3 User Manual

Initial Setup for Thor VM3

This page lists a quick outline of the steps you might take when setting up a new Thor
VM3. More instruction for each step is listed later in this guide.
Contact

Hardware Setup

1.
2.
3. Secure the optional external keyboard to either an integrated or remote mounting
4.
5.
6. Secure all cables in
7. Press the
8. Press the
Note: After the initial power on, the Thor VM3 can be configured to automatically power on,
either when power is attached or the vehicle ignition is turned on.
9. Perform

Software

This section only applies if the Thor VM3 was ordered with an operating system. For a
Thor VM3 ordered without an operating system, see
System.
Languages
The language selection and installation process varies by operating system:
•
•
Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Technical Assistance
Install RAM Mount or
Place Thor VM3 in the
bracket.
Connect Cables for any peripherals.
Connect Power.
Strain Relief Cable
Power Switch
Power Button
Touch Screen Calibration
The Thor VM3 with a Windows Embedded Standard 7 operating is delivered with an
English operating system. Additional Language Packs are available for installation
using the Region and Language
the Software tab of the
The Thor VM3 with a Windows 7 Professional operating system may be shipped with
an English only operating system. Contact
Recovery DVD in a different language. The language installed is identified on the
Software tab of the About
if you need additional help.
Install U Bracket Mount
Dock.
Clamps.
on the dock to the on position.
on the Thor VM3.
(not required for PCAP touch screen).
control panel. The language installed is identified on
About control panel.
control panel.
to the vehicle.
Thor VM3 with no Operating
Technical Assistance to order a Thor VM3
7