Wpa/Leap - Honeywell Thor VM2 User Manual

If using the Windows certificate store:
1. Check the Use MS store checkbox. The default is to use the Full Trusted Store.
2. To select an individual certificate, click on the Browse button.
3. Uncheck the Use full trusted store checkbox.
4. Select the desired certificate and click Select. You are returned to the Credentials
5. Click OK then click Commit
If using the Certs Path option:
1. Leave the Use MS store box unchecked.
2. Enter the certificate filename in the CA Cert text box.
3. Click OK then click Commit
The device should be authenticating the server certificate and using PEAP/GTC for the
user authentication.
Ensure the correct Active Profile is selected on the Main tab and warmboot. The SCU
Main tab shows the device is associated after the radio connects to the network.
Note: The date must be properly set on the device to authenticate a certificate.

WPA/LEAP

To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set EAP Type to LEAP
3. Set Encryption to WPA TKIP
4. Set Auth Type as follows:
5. If the Cisco/CCX certified AP is configured for open authentication, set the Auth
6. If the AP is configured to use shared key or passphrase, set the Auth Type radio
7. If the AP is configured for network EAP only, set the Auth Type radio parameter to
324
screen.
Type radio parameter to Open.
parameter to Shared.
LEAP.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide