Honeywell Thor VM2 User Manual page 191

Initial Configuration
1. Select Start > Settings > Control Panel > Bluetooth or tap the Bluetooth icon in the
2. Tap the Settings Tab.
3. Change the Computer Friendly Name at the bottom of the Settings display. The
4. Check or uncheck the Thor VM2 Bluetooth options on the Settings and Reconnect
5. Tap the OK button to save your changes or the X button to discard any changes.
Subsequent Use
Note: Taskbar and Bluetooth device Icon states change as Bluetooth devices are discovered,
paired, connected and disconnected. A taskbar Bluetooth icon with a red background
indicates Bluetooth is active and not paired with any device. A device icon with a red
background indicates a disconnected paired device.
1. Tap the Bluetooth icon in the taskbar or on the desktop to open the Bluetooth EZPair
2. Tap the Bluetooth Devices tab.
3. Tap the Discover button. When the Bluetooth module begins searching for in-range
4. The discovered devices are listed in the Bluetooth Devices window.
5. Highlight a Bluetooth device in the Discovered window and double-tap to open the
6. Tap Pair as Scanner to set up the Thor VM2 to receive scanner data.
7. Tap Pair as Printer to set up the Thor VM2 to send data to the printer.
8. Tap Serial Device (when Filtered mode is disabled) to set up the Thor VM2 to
9. Tap Disconnect to stop pairing with the device. Once disconnected, tap Delete to
10. Upon successful pairing, the selected device may react to indicate a successful
11. Whenever the Thor VM2 is turned On, all previously paired, live, Bluetooth devices in
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
taskbar or on the desktop.
Bluetooth Thor VM2 default name is determined by the factory installed software
version. A unique name (up to 32 characters) should be assigned to every Thor VM2
before Bluetooth Discovery is initiated.
tabs.
application.
Bluetooth devices, the button name changes to Stop. Tap the Stop button to cancel
the Discover function at any time.
device properties menu.
communicate with a Bluetooth serial device.
remove the device name and data from the Thor VM2 Bluetooth Devices list. The
device is deleted from the list after the OK button is clicked.
connection. The reaction may be an audio signal from the device, flashing LED on
the device, or a dialog box is placed on the Thor VM2 display.
the vicinity are paired, one at a time, with the Thor VM2. If the devices cannot
connect to the Thor VM2 before the re-connect timeout time period expires (default
is approximately 20 seconds for each paired device) there is no indication of the
continuing disconnect state if Report Failure to Reconnect is disabled.
179