Honeywell Thor VM2 User Manual page 140

11. When using Windows explorer to view My Device, the SD card is identified as SD
Note:
12. Remove the Thor VM2 from the
13.
14. Place the Thor VM2 face down on
15. Use a #2 Phillips bit to loosen the
16. Locate the mSATA card
17. Tilt the card at a 45º angle and insert the connector end of cards
18. Once the connector end is inserted, lower the card until the other
19. Reattach the access panel, torquing the screws to 7.0 ± 0.5 inch
20. Reinstall the Thor VM2 in the dock.
21. Restart the Thor VM2.
128
Card.
dock.
Disconnect UPS Battery.
a stable surface.
captive M3 screws on the access
panel with the mSATA and SIM
labels. This panel is on the right
hand side when the Thor VM2 is
face down with the top away from
the user.
installation slot.
into the slot.
end is captured and secured by the anchor pins.
pounds.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide