Wireless Zero Config Utility - Honeywell Thor VM2 User Manual

Wireless Zero Config Utility

•
•
To Switch Control to the Wireless Zero Config Utility
1. Select ThirdPartyConfig in the Active Profile drop down list as the active profile on
2. Warmboot the device.
The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless
Information control panel. Using the options in the Wireless Zero Config panels, setup
radio and security settings. There may be a slight delay before the Wireless Zero Config
icon indicates the status of the connection.
To Switch Control to SCU
1. To switch back to SCU control, select any other profile in the SCU Active Config drop
2. Warmboot the device.
Radio control is passed to the SCU.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
The WZC utility has an icon in the toolbar that looks like a networked computer with
a red X beside it, indicating that Wireless Zero Config application is enabled but the
connection is inactive at this time (the device is not connected to a network). The
WZC icon may not be visible until control is passed to the WZC utility as described
below.
You can use either the Wireless Zero Configuration Utility or the Summit Client Utility
to connect to your network. The Summit Client Utility is recommended because the
Wireless Zero Configuration Utility cannot control the complete set of security
features of the radio.
the Main tab.
down list, except ThirdPartyConfig.
301