Honeywell Thor VM2 User Manual page 100

Fuse Requirements
Warning: For proper and safe installation, the input power cable must be
•
Note: Note: For North America, a UL Listed fuse is to be used.
Power Cable Identification
The DC power cable is included with the dock and is one of the two styles below:
Power cable with right angle connector and 6 wires:
Power cable with straight connector and 4 wires:
Note: Correct electrical polarity is required for safe and proper installation. See
for additional wire color-coding specifics.
The Thor VM2 DC input wires (Red, Red/White DC+ and Black, Black/White DC-) and
the Blue ignition input wire are galvanically isolated. The Green ground input is used for
electrostatic discharge (ESD) protection.
Vehicle 50-150VDC Power Connection
1. Please review the
2. The Thor VM2 must not be mounted in the dock. The power switch on the dock must
88
connected to a fused circuit on the vehicle. If the supply
connection is made directly to the battery, the fuse should be
installed in the positive lead within 5 inches of the battery's
positive (+) terminal. Use VM3055FUSE (or equivalent) to
install the fuse as shown below:
For all voltages, use the 3A fuse from the kit or a slow blow fuse that has a DC voltage
rating greater than the vehicle input voltage.
Twist the red and red/white wires together and
twist the black and black/white wires together
before connecting to vehicle power.
Wiring
be turned Off. The power cable must be UNPLUGGED from the dock.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Diagram, before beginning power cable install.
Wire Color Connection
Red DC + (10-60 VDC)
Red/White DC + (10-60 VDC)
Black DC -
Black/White DC -
Green Ground
Blue Ignition Input
(optional)
Wire Color Connection
Red DC + (10-60 VDC)
Black DC -
Green Ground
Blue Ignition Input
(optional)
Wiring Diagram