Serial Offset: Seo; Serial Offset Setting; Model Type* Setting Range [Mm] Lp-Sxx0(W) Lp-Sxx5(W) Lp-Sxx2; Lp-Mxx5 - Panasonic LP-M Series Serial Communication Manual

■ Serial offset: SEO

Sets the coordinates specified for "Serial offset function" to change coordinates for each marking.

Serial offset setting

STX SEO S
Data length
Name
[byte]
X offset 8
Y offset 8
Z offset
(Effective only
8
LP-M / LP-Z
series)
θ offset 7
Laser power
3
correction
* For the detail of the model type, refer to "Target laser marker" (P.4).
Reference
• The command for serial offset input is enable when serial offset is set with external offset condition.
• Transmission is available only during remote control and when the internal shutter is opened ("Reception mode ON" is
not set for command reception permission (MKM command)).
• Set "Serial Offset" for "External Offset Condition" before using this command.
• When using this function (serial offset), transmit this command by every marking. Otherwise it does not become marking
ready condition, and marking is not available.
• For resetting the data, either set "reception mode ON" for the command reception permission (MKM command), or close
the shutter.
• SEO command cannot be used with the rank function and equidistant marking to moving object.
• If SEO command is used with the marking to the flying object, make sure that the marking interval time is enough to the
required period to input the marking data and to confirm the marking ready output.
• Refer to "Timing chart for serial offset marking" (P.90) for the timing chart for this command transmission.
[X offset] [Y offset] [Z offset]
[ θ offset] [Laser power correction]
34-byte
Description
Model type* Setting range [mm]
LP-Sxx0(W) "-045.000"–"+045.000"
LP-Sxx5(W) "-080.000"–"+080.000"
LP-Sxx2 "-027.500"–"+027.500"
LP-Mxx0/LP-Zxx0 "-060.000"–"+060.000"

LP-Mxx5

"-110.000"–"+110.000"
LP-Mxx6/LP-Zxx6 "-165.000"–"+165.000"
Model type* Setting range [mm]
LP-Sxxx(W) "+000.000" (fixed)
LP-Mxxx "-022.000"–"+022.000"
LP-Zxxx "-025.000"–"+025.000"
"-180.00"–"+180.00"
"000"–"999" [%]
ME-LPMSZ-SR-9
(Check sum) Delimiter
Remarks
• LP-Sxxx/LP-SxxxW：
As this item is not available for the
LP-S series, set to "+000.000".
• LP-Mxxx/LP-Zxxx：
The offset of Z coordinate is
indicated.
The correction ratio is calculated using
the value set at the laser condition as
100%.
89