Vec Logo Conditions (Cad Condition) : Cdc; Readout Request Out Of Vec Logo - Panasonic LP-M Series Serial Communication Manual

■ VEC logo conditions (CAD condition) : CDC

Sets the marking condition of VEC (work shape converted for laser marker) logo file.
Setting / Readout data of VEC logo
Sub
STX CDC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.

Readout request out of VEC logo

STX CDC R
Data length
Name
[byte]
CAD No. 2
X position 7
Y position 7
Magnification 5
Rotation angle 6
Laser power
3
correction
Scan speed
3
correction
(Laser
pulse cycle (3)
correction)
* For the detail of the model type, refer to "Target laser marker" (P.4).
Reference
• Logo file for the LP-F series is treated as one for LP-F10/F10W (marking area 90 mm x 90 mm). Logo file used for
special-order model (marking area other than 90 mm x 90 mm) is not supported.
• When a logo file for the LP-F series is used, X/Y scales are automatically adjusted to the same size in the LP-M/LP-S/
LP-Z series. X/Y scales for readout of CAD condition may be different from values specified in CAD condition setting.
• In readout response, the digit of 1 μm or 0.01° is rounded down.
• The laser power correction, speed scan correction and laser pulse cycle correction are out of the setting range of the
LP-F10/F10W, readout cannot be performed. (NAK15 is returned.)
• When the setting is performed using this command, the layer No. is "0".
• Setting with this command in the LP-F10W mode, the laser pulse cycle correction is set to 100%.
• For LP-SxxxW type, the laser pulse cycle correction setting does not affect the marking. Also this setting is not saved in
the file.
[CAD No.] [X position] [Y position] [Scale] [Rotation angle]
[Laser pulse cycle correction] [Scan speed correction]
[Laser pulse cycle correction]
36-byte (LP-F10 mode), 33-byte (LP-F10W mode)
[CAD No.]
2-byte
Description
"00"–"15"
"-300.00"–"+300.00" [mm]
Model type* Setting range [times]
LP-Sxx0 "00.10"–"01.98"
LP-Sxx5 "00.10"–"03.53"
LP-Sxx2 "00.10"–"01.21"
LP-Sxx0W "00.10"–"02.27"
LP-Sxx5W "00.10"–"04.04"
LP-Mxx0/LP-Zxx0 "00.10"–"03.03"
LP-Mxx5 "00.10"–"05.56"
LP-Mxx6/LP-Zxx6 "00.10"–"08.34"
"-180.0"–"+180.0" [°]
"000"–"200" [%]
"050"–"200" [%]
"050"–"200" [%]
ME-LPMSZ-SR-9
(Check sum) Delimiter
Specifies the origin coordinate of the logo.
The angle of rotation centering on the
origin position of CAD file, is indicated.
• The correction ratio is calculated using
the value set at the laser condition as
100%.
• Laser Pulse Cycle Correction can be
specified only in LP-F10 mode.
(Check sum) Delimiter
Remarks
147