Guide Ld Display: Gid; Setting Of Guide Ld Display - Panasonic LP-M Series Serial Communication Manual

■ Guide LD display: GID

Controls radiation of red guide laser for marking position confirmation.

Setting of guide LD display:

STX GID S
Data length
Name
[byte]
Guide laser
1
type
Scan speed (5)
Z offset
(Effective only
(8)
LP-M / LP-Z
series)
* For the detail of the model type, refer to "Target laser marker" (P.4).
Reference
• Omit the Z offset too if omitting the scan speed setting.
• This command is available only when the DIP switch No. 2 on the rear side of the controller is ON.
• You can start the guide laser radiation when the internal shutter is closed or when the "command reception mode ON" is
set by Command reception permission (MKM) command.
• The internal shutter is automatically opened and closed at the time of start and stop of the radiation.
• The guide laser stops automatically after about one minute even if the stop request command was not sent. At this time
the internal shutter is automatically closed.
• After the guide laser emission with "command reception mode ON" status by MKM command, the shutter is opened
when the "command reception mode OFF" is set by MKM command.
• Do not execute any other operation including the shutter opening/closing and sending MKM command while the guide
laser is emitted.
[Guide laser type] [Scan speed] [Z offset]
Max. 14-byte
Description
"0": Display stop
"1": Marking area
"2": Marking character
"3": Work image display
"4": Dual pointer
Model type* Setting range [mm/s]
LP-Sxx0/LP-Sxx5/
LP-Mxx0/LP-Mxx5/ "00001"–"06000"
LP-Zxx0
LP-SxxxW/LP-Sxx2 "00001"–"03000"
LP-Mxx6/LP-Zxx6 "00001"–"04000"
Model type* Setting range [mm]
LP-Sxx(W) "+000.000" (fixed)
LP-Mxxx "-022.000"–"+022.000"
LP-Zxxx "-025.000"–"+025.000"
ME-LPMSZ-SR-9
(Check sum) Delimiter
Remarks
The moving speed of the guide indication
is indicated. (omissible)
• LP-Sxxx/LP-SxxxW:
As this item is not available for the LP-S
series, set to "+000.000" or no data.
• LP-Mxxx / LP-Zxxx:
Being effective when Guide laser type
is "1": Marking Area or "4": Dual Pointer,
it indicates Z displacement of guide
display in comparison to the base work
distance. (omissible)
43