Layer Condition: Suf; Plane And Cylinder - Panasonic LP-M Series Serial Communication Manual

■ Layer condition: SUF

[Supported models: LP-Mxxx/LP-Zxxx]
Sets the layer condition for 3D marking for LP-M / LP-Z series.
Setting / Readout data of layer condition/response data at the time of readout
STX SUF
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of layer condition
STX SUF
1. Plane and cylinder (Data length: 70-byte)
Data length
Name
[byte]
Layer No.
Work shape
Center position X
Center position Y
Center position Z
Rotation angle X
Rotation angle Y
Rotation angle Z
Height
Width or diameter
Defocus
* For the detail of the model type, refer to "Target laser marker" (P.4).
Reference
• Set the defocus value so that the sum of the Z coordinate to be actually marked and the defocus value is in the range of
the interwork distance (specification value) +/-22.000 mm (LP-M) or +/-25.000 mm (LP-Z).
86
Sub [Layer No.] [Work shape]
[Setting data (varies depending on work shape)]
[Layer No.]
R
2-byte
2 "00"–"15"
"0": Plane
1 "1": Cylinder convex
"2": Cylinder concave
8
Model type*
LP-Mxx0/LP-Zxx0
8
LP-Mxx5
8
LP-Mxx6/LP-Zxx6
7 "-090.00"–"+090.00" [°]
7 "-090.00"–"+090.00" [°]
7 "-180.00"–"+180.00" [°]
7
Model type*
LP-Mxx0/LP-Zxx0
LP-Mxx5
LP-Mxx6/LP-Zxx6
7
Model type*
8
LP-Mxxx
LP-Zxxx
(Check sum)
Description
Setting range [mm]
"-060.000"–"+060.000"
"-110.000"–"+110.000"
"-165.000"–"+165.000"
Setting range [mm]
"001.000"–"120.000"
"001.000"–"220.000"
"001.000"–"330.000"
Setting range [mm]
"-022.000"–"+022.000"
"-025.000"–"+025.000"
ME-LPMSZ-SR-9
(Check sum)
Delimiter
Remarks
The center coordinate of 3D work is
indicated.
• When the work shape is "0": Plane,
specify the plane length (vertical).
• When the work shape is "1", "2":
Cylinder, specify the cylinder
length (height).
• When the work shape is "0": Plane,
specify the width (lateral) of plane.
• When the work shape is "1", "2":
Cylinder, specify the diameter of
cylinder.
Delimiter