Changing The Marking Characters - Panasonic LP-M Series Serial Communication Manual

■ Control sample 1-1 : Changing the marking characters
1. Laser pumping (ON)
2. Marking character string setting
3. Shutter setting (open)
4. Status request
5. Marking trigger
Mark the same
character.
9. Shutter setting (close)
10. Laser pumping (OFF)
Reference
• Other than STR and MCS command, SIN command can be used for changing character of marking command. SIN
command is recommended to use in case faster processing is required.
• For LP-Mxxx-S type, open the laser gate to turn ON the ready signal.
Laser gate can be controlled with any timing regardless of the command sequence by the external signal input.
Remote mode ON
LSR command
MCS command or STR command
SHT command
STS command
"READY": ON
Yes
MRK command
Change the character
to be marked
To finish the
marking
6. Command reception mode ON
7. Marking character string setting
8. Command reception mode OFF
SHT command
LSR command
Remote mode OFF
ME-LPMSZ-SR-9
Send the character
to be marked.
No.
Send STS command
again after a while.
Change the character.
MKM command
MCS command or STR command
MKM command
* To memorize the last marked
character into the laser marker,
save it with "File Overwriting
Registration (FOR)".
25