General Character Condition: Scc - Panasonic LP-M Series Serial Communication Manual

■ General character condition: SCC

Sets the marking pitch for bold character and kerning for marking proportional character.
Setting / Readout data of general character condition
Sub
STX SCC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of general character condition
STX SCC R
Data length
Name
[byte]
Marking pitch 5
Kerning 1
[Marking pitch] [Kerning]
6-byte
(Check sum) Delimiter
Description
"0.010"–"2.000" [mm]
"1" : Level 1
Minimize the base point of the
character interval with this condition.
The letter-spacing of the letter "i" and
"l" (small letter "L") are recognized as
"0".
"2" : Level 2
Set the origin point of the character
with intermediate degree between
the character interval set with Level
1 and Level 3. The character widths
of "i" and "l" (small letter "L") become
1/4 of each character width.
"3" : Level 3
Maximize the origin point of the
character interval with this condition.
The character widths of "i" and "l"
(small letter "L") become 5/8 of each
character width.
ME-LPMSZ-SR-9
(Check sum) Delimiter
Remarks
The marking pitch for the bold character is
indicated.
The minimum value of character interval
with proportional form is specified.
85