Step & Repeat Fine Adjustment: Sra; Setting / Readout Data Of Step & Repeat Fine Adjustment - Panasonic LP-M Series Serial Communication Manual

■ Step & repeat fine adjustment: SRA
Sets the fine adjustment of "Step & repeat" to mark the same marking contents on multiple locations in one file.
Setting / Readout data of step & repeat fine adjustment
STX SRA
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of step & repeat fine adjustment
STX SRA
1. Setting deletion (data length: max. 9-byte)
Data length
Name
[byte]
List line 4
Fine adj. type 1
Number of
(4)
delete line
2. In case of "Single" as fine adjustment type (data length: max. 45-byte)
Data length
Name
[byte]
List line 4
Fine adj. type 1
Target row 3
Target column 3
Fine tune X 8
Fine tune Y 8
Fine tune Z
(Effective only
8
LP-M / LP-Z
series)
Rotation angle
(7)
*2
Laser power
(3)
adjustment *2
*1 : For the detail of the model type, refer to "Target laser marker" (P.4).
*2 : When both setting values of the rotation angle and laser power adjustment are "0", those settings can be omitted.
94
[List line] [Fine adj. type]
Sub
[Varies depending on the type of line adj.]
Max. 605-byte
[List line]
R
4-byte
Description
"0000"–"0399"
"0": Setting deletion
"0001"–"0400"
Description
"0000"–"0399"
"1": Single fine adjustment
"001"–"400"
"001"–"400"
Model type*
LP-Sxx0(W)
LP-Sxx5(W)
LP-Sxx2
LP-Mxx0/LP-Zxx0
LP-Mxx5
LP-Mxx6/LP-Zxx6
Model type*
LP-Sxxx(W)
LP-Mxxx
LP-Zxxx
"-180.00"–"+180.00" [°]
"-50"–"+50" [%]
(Check sum)
If only the first line in the list line will be deleted, the setting
can be omitted.
Setting range [mm]
"-045.000"–"+045.000"
"-080.000"–"+080.000"
"-027.500"–"+027.500"
"-060.000"–"+060.000"
"-110.000"–"+110.000"
"-165.000"–"+165.000"
Setting range [mm]
"+000.000" (fixed)
"-022.000"–"+022.000"
"-025.000"–"+025.000"
ME-LPMSZ-SR-9
(Check sum) Delimiter
Delimiter
Remarks
Remarks
• LP-Sxxx/LP-SxxxW:
As this item is not available for the
LP-S series, set to "+000.000".
• LP-Mxxx/LP-Zxxx:
Specifies the amount of adjustment
for Z axis.